Derby D70 Rigid PVC Adhesive 1kg

Product description
Derby D70 Rigid PVC Adhesive is a special adhesive for bonding rigid PVC-U parts (plate, pipe, elbow, etc.).

Application Areas
It is used for joining the joints of pressure pipes made of U-PVC, such as potable water, gas pipes and agricultural irrigation pipes. Resistant to water, alcohol, oil and gasoline. It complies with the German DIN 16970 standard.

Application
Pipe ends and joints must be cut at the right angle and deburred. Adhesion surfaces must be cleaned beforehand. The surfaces on which the adhesive will be applied should be marked for correct application. If it is wet, it should be dried and cleaned of oil and dirt. Mix the hard PVC Adhesive before use. Adhesive should be applied smoothly and evenly. To avoid mistakes, apply the first coat into the part to be threaded. Then apply along the pipe up to the marked area. To reduce errors, the pipe should be applied twice. Combine the pipe and the part to be bonded without turning it, without wasting time. Hold the pieces together for a few seconds until curing begins. Clean up any excess with a cloth. As the product cures quickly, the parts must be assembled within 3 minutes after the application of the adhesive. If the adhesive is applied thinly and the air temperature is high, this time is even shorter. Do not apply pressure to the system during the first 5 minutes of bonding the parts. Under +10 °C, the curing time increases 2-3 times. Pressure tests can be done after 24 hours.

Shelf life
Do not store below +5 °C and for more than 12 months. If the glue thickens from the cold, move it to a warm room and stir occasionally.